Craftsman Lawn Tractor Safety Switch Troubleshooting. Secondly, you will notice that the wires are plugged in underneath a connector. If the operator stands, the spring forces the gap open and interrupts the electrical ignition circuit.
I have a Craftsman lt3000 riding lawn mower, model 917 from www.justanswer.com
Remove the plastic cover on the deck that protects the blades belt assembly. Mounted between two plates, the switch's spring compresses under the weight of the person sitting in the operator seat and completes an electrical circuit. Secondly, you will notice that the wires are plugged in underneath a connector.
Before You Replace The Blade Interlock Switch In Your Riding Mower Make Sure The Engine Has Cooled The Ignition Switch Is In The “Off” Position And The Key Has Been Removed.
Norman bailey, check these things first: 1. At least not on this side of the internet. This is a safety feature in case someone were to fall off the mower while it was moving or to prevent the power from being put into gear without anyone to control it.
Now The Way We Test This Type Of Switch Is To Turn The Switch In The Off Position Once You Have Got Your Key Switch Inserted Into The Lawnmower Switch And Turn It Into The Off Position.
Step 2:disconnect the spark plug of your mower. Test and replace faulty safety switch: Once you hear the clicking noise, proceed to the next step and you’re going to put your digital multimeter.
The Safety Switch On A Craftsman Mower Is Designed To Shut The Engine Down If No One Is Seated On The Tractor Seat.
Prepare your lawn mower for repair. Disabling the safety switch obviously removes this safety feature from the mower,. Check the hydraulic fluid in the transmission.
Mounted Between Two Plates, The Switch's Spring Compresses Under The Weight Of The Person Sitting In The Operator Seat And Completes An Electrical Circuit.
Have craftsman riding mower w/3blades. The safety switch is made of the plastic harness. Most lawn mowers have the seat safety switch located under the seat.
Set The Mower Deck On The Lowest Setting.
Your mower will not start when either the ignition switch or coil is bad: Lift the seat of the mower. This plug is the mower’s seat safety switch plug that you are required to bypass.
