Ford F350 Instrument Cluster Not Working. Check fuse 19 under the dash if this is the case u also need a new shifter handle happend to me the gauge cluster would shut down.if its lights to then theres a bigger issue check the plug at the back of the lcuther must of come loose Instrument cluster does not work.
2006 Ford F250 F350 Speedometer Cluster Instrument Panel from www.ebay.com
But the gas, temp, speed, rpm battery, & oil are all registering nothing as if the truck was off. Instrument cluster does not work. Here i explain the issue and w.
Dome Light Stays Illuminated No Matter What I Try To Shut It Off.
If your ford f350’s speedometer is not working, the first place to go would be to check the service engine soon. The other thing to check is on the back of the insturment cluster where the electrical plugs go in, make sure its nice shinny copper color (see pic) and also, the 4 rectangle metal things in the picture, they just lay on top of the copper foil, agin an area for poor connections, as you can see i soldered them (all of them on the cluster) just to make sure i wouldn't have to worry. This morning i went to leave for work and noticed that my instrument cluster was not working.
The contact was unaware of the vehicle's speed or oil pressure. If loop is not cut, cut printed circuit at loop. Friday, january 30th, 2009 at 11:54 pm.
Pulled The Dash, Unscrewed The Cluster, Left The Two Giant Harnesses Plugged In, Unhooked The Gear Position Needle And Flipped That Cluster Up On The Dash To Have At It.bad Move.
Ok, looking at the instrument panel and ecu are going to be where to start. 2001 ford f350 v10, my gauge cluster stopped working. Press and hold the reset button and do not leave it.
Almost Everything Runs Through That Damn Cluster.
1.with the key in the ignition and in the off position press and hold the odometer / trip button. Found the left low beam headlight fuse blown. They sent it back and said it checked fine.
1994 Ford F350 Fule Gauge Stopped Working, Is It Fused!
In the case of a ford, the reset button will be the only button on the dash and is usually situated on the right side of the dashboard. Either i broke a foil on the pcb by applying tension to the harnesses i left plugged in, or the burnt out bulbs were burntout for a reason. Any help will be appreciated.
