Gmc Sierra Parking Brake Adjustment. The passengerside access hole is found above axle, and difficult to see. A gmc sierra 2500 hd parking brake system adjust costs between $104 and $131 on average.
How to get intermediate and rear parking brake cables to from www.justanswer.com
You're looking for a slight drag of the brake shoes when you spin the wheels. Pull or step on the parking brake lever to engage the brake shoes. Adjusting the parking brake should be simple on most models, especially when the parking brake cable adjustment is exterior of the brake drum assembly or for disc brake parking brake systems.
Difference Should Be.6604 Mm Or.02 In.
As a last step, slide the rotor off to expose the parking brake mechanism. Caliper should slide right out. Observe the park brake lamp on the instrument cluster.
There's A Plastic Dust Cover About 1/4 X 1 That You Remove, And Use A Drum Brake Adjuster Tool.
Get a free detailed estimate for a repair in your area. The adjustment for the parking brake is usually located near the back of the brake pedal. Jack both back wheels up, spin then wheel and then adjust them until the wheel begins to drag, once it drags a bit, adjust them back a touch, then pop the grommets back in.
The Driverside Access Hole Is Below Axle, Easily Accessable.
Finally, retighten the adjusting nut and release the pedal. It should be noted that some parking brakes are adjusted from within the brake drum, and removing a brake drum which has not received proper maintenance can prove difficult or. This is where the cables connect to the park brake adjuster at the backing plate.
Depress Parking Brake 18 Degrees And Insert Pin Through Hole (1) Fig.
Tighten or loosen your parking brake to make it work again about press copyright contact us creators advertise developers terms privacy policy & safety how youtube works. You needed a brake spoon and its a quick job. The lever should stop firmly about halfway through its travel.
You Will Need To Rotate And Angle The Parking Brake Shoe To Get It Around And Off The Hub.
Pull or step on the parking brake lever to engage the brake shoes. Pull rearward on the front park brake cable until the pedal drum (2) reaches its full reset position. This creates space between the metal clip and the inner side of the brake shoe.
