2002 Dodge Durango Crankshaft Position Sensor Location. This is a short video giving guidance on replacing the crankshaft position sensor on a 2002 dodge durango with a 5.9l v8 engine. They are both located towards the back of the engine on the top.
PC284 For Dodge Ram 1500 20022009 For Durango 4.7 from www.ebay.com
Position the new sensor in the same way the old one came out. At the same time i am repla. The tps is on the side of the throttle body the crankshaft position sensor is on the passengers side of the engine block near the transmission.
Crank Sensor On The Durango Is Located On The Passenger Side Of The Vehicle Just At The Rear Of The Cylinder Head, At The Base Of The Block Where The Trans Bell Housing And Engine Block Mate Together You Should See To Bolt And A Wiring Harness With A Two Wire Connector There.
It is easier to remove/install sensor from under vehicle. This is a short video giving guidance on replacing the crankshaft position sensor on a 2002 dodge durango with a 5.9l v8 engine. The relay should click closed when you start cranking and stay closed.
This Sensor Uses A Reluctor To Gauge The Position Of The Crank.
Unplug the harness connector and undo the two bolts. The sensor is bolted to the block near the right or driver's side cylinder head. If you chose to go from above, you will need to lie down over the engine and reach your arms behind the head.
Turn The Ignition Key To The On Position And Turn The Engine By Hand Using The 1/2 Ratchet Wrench And Appropriate Socket On The Crankshaft Pulley.
The powertrain control module and/or crankshaft sensors end up being replaced, but the problem is hard to diagnose and dangerous because it occurs without warning and while driving. The pcm uses the signal to determine what the engine speed is and what position the crankshaft is in. The tps is on the side of the throttle body the crankshaft position sensor is on the passengers side of the engine block near the transmission.
It Is Easier To Remove/Install Sensor From Under Vehicle.
Pull the old sensor out, and set it aside. They changed the crank sensor engine ran 30 minutes and quit same code. Contains all camshaft and crankshaft position sensors for the vehicle.
They Can Be A Bear To Get Out, So Giving It A Good Soaking With Some Type Of Penetrating Oil.
My durango began doing this about a. If it stays closed, then it's something else. I think you will find it goes into the passenger side of the block back by the rear of the engine.
