2004 Ford Explorer Transmission Fluid Change. I'd only flush every 60k and just do a trans fluid and filter replacement every 30k. I have a 2004 ford explorer 4.0, 4wd, 154,674mi.
Oil and Filter Replacement 20002005 Ford Explorer YouTube from www.youtube.com
Check both o2 sensor (s) and catalytic coverter. Lower your explorer, then start the engine and move the transmission shift selector through every gear and back to park. then let the transmission reach operating temperature. The transmission fluid capacity on your explorer is 12.7 quarts.
With The Engine Still Running, Check The Transmission Oil Level.
2004 ford explorer transmission filter (a/t) 2004 ford explorer transmission mount. If they were done at say, jiffy lube or some ma/pa shop, you won't be able to find any records. Park your 2004 ford explorer on a flat surface, and then let the vehicle cool down.
Obviously, You’ll Have To Be A Lot More Careful If.
2004 ford explorer transmission cable shift (a/t) 2004 ford explorer transmission control module. Brought suv in for recall of transmission fluid additive/replacement. The average cost for a ford explorer transmission fluid change is between $342 and $373.
Park Your Vehicle On A Flat Surface.
Install the fluid drain plug; 2004 ford explorer transmission oil cooler. If you also would like to know what type of transmission fluid to use then it is motorcraft mercon v atf.
I'd Only Flush Every 60K And Just Do A Trans Fluid And Filter Replacement Every 30K.
P0420 means catalyst below threshold. About press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new features press copyright contact us creators. Warm up the engine and check the fluid level with the engine running.
Based On The Owner’s Manual, Decide Whether To Check The Transmission Fluid With The Engine On Or Off.
The transmission fluid capacity on your explorer is 12.7 quarts. This range does not include taxes and fees, and does not factor in your specific model year or unique location. Get a pump at local auto parts store with transmission fluid and start pumping it with 1/2 quarts then let it drain for two minutes then check it again to get a correct amount of fluid just be patient to let it drip once it reach the normal temperature it’s time to close the plug then done!!
