Kenmore Elite Dryer Remove Front Panel. Removing kenmore elite control panel [ 0 answers ] for the life of me, i cannot determine how to remove the top control panel of a kenmore elite 110.24952300 washing machine. Step 7 remove the screws at the base of the toe panel.
Trying to replace the door switch on a Kenmore electric from www.justanswer.com
I have a kenmore heavy duty 90 series dryer, model 110 97591240. Step 7 remove the screws at the base of the toe panel. Lower the front panel out of the way.
Step 7 Remove The Screws At The Base Of The Toe Panel.
Set your multimeter to the r x 1 scale and touch the leads to the thermal fuse terminals to test for continuity. Open the lint trap cover if there is one and remove the lint trap. Step 8 remove the two.
Unplug Your Dryer From The Electrical Outlet.
Grasp the top of the dryer firmly with one hand on either side and pull toward you sharply and then lift up slightly. Remove the large red wire from terminal a on the timer unit in the control panel. I want to hinge it back so i can remove the cabinet and access the pump.
Pull The Bottom Of The Front Panel Out Slightly And Pull Down To Disengage The Top Clips.
One may also ask, how do you reset a. I'm having a problem, have ordered the control panel but can't figure out how to remove the panel to replace it. I see there are instructions here about using a putty knife to get it out, but try for th e life of me, i can't seem to get this to work.
Unplug The Kenmore Laundry Center Power Cord From The Wall Outlet.
Remove the kick panel beneath the washer door. How do i remove the front of a kenmore elite dryer. I have removed the front lower panel and removed the accumulated lint.
Disconnect The Door Switch Wires, Spark Gap And The Three Wires That Connect To The Control Board.
To remove the bulkhead take out the 4 screws at the bottom and loosen up 2 at the top. It may be in a plastic casing. Step 6 open the dryer door.
