Swirl Control Valve Nissan Sentra 2003. Sold by thetiny1s ( 89) 100.0% positive feedback contact seller. I have gone to 3 different places and all tell me to replace the swirl control valve, but every nissan dealership i call for the part says i do not have this particular part on my car.
Nissan sentra p1138 swirl control valve from automotorpad.com
P1137 2005 nissan sentra ; Might need to source a used one from a wrecker. Check engine light came back on and same p1130 code.
Install Or Connect The Following:
Negative battery cable air inlet tube harness bracket wiring at the starter starter; 68 technical service bulletins (tsbs) compare sentra years; P1137 2005 nissan sentra ;
It's Just At Around 1700Rpm It Cuts Out And Will Come Back.
The sensor responds to the valve shaft movement. When it isn't working, the engine still runs smoothly and idles well. These are for the active shutters in the intake that change the intake paths to help engine performance.
Picture 2 Shows The Ground Location.
Replace starter on 2005 nissan sentra remove or disconnect the following: Will this swirl control valve fit my nissan sentra 20. Sold by thetiny1s ( 89) 100.0% positive feedback contact seller.
Often Times, The Ground Fails, So Check That First.
Parts fit for the following vehicle. Choose top quality brands hitachi, standard motor products. I got a code p1138 on my sentra 1.8s automatic transmition year 2005 vin:
The Auto Repair's Diagnosis Time And Labor Rates Vary By Location, Vehicle's Make And Model, And Even Your Engine Type.
I have gone to 3 different places and all tell me to replace the swirl control valve, but every nissan dealership i call for the part says i do not have this particular part on my car. A whole ordeal with the swirl control valve on a 2000 sentra 1.8l. Put 2 new o2 sensors in.
